If the RxNE bit is set and the data in the DR register is not read before the end of the last data reception, the BTF bit is set by hardware and the interface waits until BTF is cleared by a read in the DR register, stretching SCL low. 这个BTF位在主接收模式下,为什么在判断RXNE 等于1后,读DR的数,然后判断BTF是否为1,为1 的话再读一次DR。WHY? |
高主频情况下程序运行进入HardFault_Handler
stm32的fsmc总线上同时挂载LCD屏和SRAM需要怎么设置
高主频情况下进入会硬件错误
STM32F407 USB的IN端点只能是0x81么?
STM32F407输出方波最高频率
mdk5添加头文件路径检索不出来文件
STM32F407使用DMA读取FSMC数据问题
stm32f407进入boot里,通过DFU更新程序,没有识别到usb设备
STM32F4作为SPI从机,主机发送完数据后,从机没有正确进入中断
STM32F407 USB怎么测试接口的极限速度
评分
查看全部评分
评分
查看全部评分