STM32F103 USB CAN 使用【悬赏问答】

joeen63 提问时间：2012-8-15 16:47 /

您好,
我使用STM32F103 48pin , PA11 PA12為USB(使用HID) , PB8 PB9為CAN,
當USB接上時會找到USB裝置,執行CAN傳送,結果USB會斷掉(電腦的裝置管理員顯示錯誤),
而且產生死機現象(一直中斷USB_LP_CAN_RX0_IRQHandler())
     CAN1_Init();
     RCC_APB1PeriphClockCmd(RCC_APB1Periph_CAN, DISABLE);
     USB_Cable = 1;
     USB_Port_Init();
          if(KEY1 == 0)
           {
              USB_Cable_Config(DISABLE);
              CAN_Write();
              Dly10ms();
              USB_Cable_Config(ENABLE);
          }
void CAN1_Init(void)
{
     NVIC_InitStructure.NVIC_IRQChannel = USB_LP_CAN_RX0_IRQChannel;
     NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0;
     NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0;
     NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;
     NVIC_Init(&NVIC_InitStructure);

     CAN_DeInit();
     CAN_StructInit(&CAN_InitStructure);
     CAN_InitStructure.CAN_TTCM = DISABLE;
     CAN_InitStructure.CAN_ABOM = ENABLE;
     CAN_InitStructure.CAN_AWUM = DISABLE;
     CAN_InitStructure.CAN_NART = DISABLE;
     CAN_InitStructure.CAN_RFLM = DISABLE;
     CAN_InitStructure.CAN_TXFP = ENABLE;
     CAN_InitStructure.CAN_Mode = CAN_Mode_Normal;
     CAN_InitStructure.CAN_SJW = CAN_SJW_1tq;
     CAN_InitStructure.CAN_BS1 = CAN_BS1_3tq;
     CAN_InitStructure.CAN_BS2 = CAN_BS2_5tq;
     CAN_InitStructure.CAN_Prescaler = 4;
     CAN_Init(&CAN_InitStructure);

     CAN_FilterInitStructure.CAN_FilterNumber = 0;
     CAN_FilterInitStructure.CAN_FilterMode = CAN_FilterMode_IdMask;
     CAN_FilterInitStructure.CAN_FilterScale = CAN_FilterScale_32bit;
     CAN_FilterInitStructure.CAN_FilterIdHigh=((MAIN_CAN_ID16;
     CAN_FilterInitStructure.CAN_FilterIdLow=((MAIN_CAN_ID