我想对STM32G031K8T6独立供电,以测试ADC功能。 按照UM2591的描述:使用3V3供电时,要断开SB2和SB3。我照做后,使用稳压源3.3V供电,固件不能运行。必须在断开JP1使用3V3供电VDD,同时USB要插上,固件才能跑起来。 注意到这样一段话: 6.4 Power supply The power supply is provided either by the host PC through the USB cable, or by an external source: VIN (7 V - 12 V), +5V (5 V) or +3V3 (3.3 V) power supply pins on CN4. In case VIN, +5V or +3V3 is used to power the STM32G0 Nucleo-32 board, this power source must comply with the standard EN-60950-1: 2006+A11/2009, and must be Safety Extra Low Voltage (SELV) with limited power capability. In case the power supply is +3V3, the STLINK is not powered and cannot be used 不知是什么意思。 难道STM32G031的供电还有别于以往的MCU?需要专用电源芯片? |
adc采集电压
关于使用STM32G030C8T6的串口收发过程中串口接收问题
STM32G0B1的CAN自动重发
用stm32cubeide生成的STM32G030F6P6代码只要一开中断,任何中断程序都会跑飞.
STM32G0B1CBT6 双Bank升级,运行Bank2上Flash不能写问题
有关STM32G0B1RET6芯片FLASH擦除问题
STM32G030烧录程序
Stm32G071 i2c slave配置问题
STM32G030 不能下载程序 0xFFFF0040
STM32G0是否支持trace?
谢谢。请问你来自ST吗?
谢谢。请问你来自ST吗?
我是爱好者,不是官方支持
无论如何,还是谢谢你们两位的提示。真没有怎么细看原理图。这个开发板做的真是奇葩 and 廉价感爆棚
真的是因为便宜才买的,呵呵,自己搭建别的外设也算方便吧